Some of the links below are affiliate links, meaning, at no additional cost to you, I will earn a commission if you click through and make a purchase.
This is my new lautering manifold. It’s not perfect, but it’ll do, I hope–its inaugural run will be on the 6 September Brew Day. The whole thing is of a piece, except for the connection to the drain fitting (the uppermost bit of copper, in the picture). So, it’ll just pull out for cleaning. I started with a hacksaw yesterday putting in the slots (on the underside, not visible in the picture), but got smart today & pulled out the jigsaw with a metal blade. The whole thing, when attached in my new mash tun (a 70-qt Ice Cube cooler), sits evenly along the bottom. I’m probably going to get a bit of fluid loss with the design (it has to angle up to get to the drain), but as long as my grasp of fluid dynamics is good, I figure it’ll be the same as or less than my fluid losses in the cylindrical cooler using the Bazooka screen.